paint kits           Used your browser button to go back

         

How to use BondFX...
ALWAYS MAKE A TEST FIRST…!!!

BondFX is a simple 50–50 mix (1 part A to 1 part B) and has a working time of 2 to 3 minutes and a cure time of 8 minutes.
The bond gets stronger after several hours.

Surface coating by brush:
Brush or stipple 1 to 2 coats of BondFX over the entire surface to be painted. For best results, painting should be done on a fresh silicone piece and should be painted as soon as possible after removing from mold.
We strongly recommend that the cured piece to be painted be no more than 2 days old.
Tin Based silicones should be painted as soon as possible.

BondFX applied by spray or airbrushing:
Spray a minimum 4 coat of BondFX over the entire surface to be painted. Painting can be done immediately with FuseFX Platinum silicone paints.
A working time of 25 minutes can be achieved by diluting with a high grade solvent (Toluene, Naphtha...) by adding 1 part of mixed BondFX to 1.5 to 2 parts solvent.
For best results, painting should be done on a fresh silicone piece
Tin Based silicones should be painted as soon as possible.

BondFX as a surface coat –
You can now pour Platinum Based silicone in a Tin Based silicone mold.
For best results, FuseFX Royal JeL-E mold release should be used prior to the BondFX application.
Apply BondFX by brush (2 to 3 coats) or sprayed several coats (minimum 6 coats) into a Tin Based Silicone mold rendering the surface ready to pour Platinum Based Silicone.

BondFX silicone encapsulator –
Apply 2 to 3 coat or airbrush several coats of BondFX on the inside surface of the molds to create a soft strong skin.
The surface is now ready for the gelled silicone.

BondFX for repairing seams in silicone – (you will need FuseFX Smoothie for this project)
Thicken a small batch of BondFX. Work quickly, BondFX cures quickly.
Apply to area to be seamed.
Next spray a coat of FuseFX Smoothie over the wet BondFX. Smoothie will allow you to move and sculpt the BondFX without diluting it, shaping it to the desired texture. Add more Smoothie if needed.
Once the BondFX has cured, you must wash off the Smoothie with warm water. The surface is now clean and ready for additional coats of BondFX if needed.